Grizzly Cordless Saw G4816 User Manual

G4816 G4817 G4818 G4819 Instructions  
1. Remove band saw blade per instructions in your manual.  
2. Remove both upper and lower blade guides.  
3. Install ball bearing guides in place of old guides.  
4. Re-install blade.  
5. Set the bearing guide so the bearing just clears the teeth of the blade. The blade will be damaged if  
the bearing comes in contact with the teeth during operation.  
6. Loosen both thumb screws on the upper bearing guide.  
7. Rotate each eccentric shaft until the bearing just touches the side of the blade. Tighten down the  
thumb screws. Make sure the bearing guides are not pinching the blade. This can cause premature  
bearing wear.  
8. Repeat steps 5-7 for the bottom bearing guide.  
9. If access to the thumb screws is limited or they interfere with a guard or bracket, replace them with  
hex bolts. Be sure not to over tighten!  
10. Reset the back-up bearing per the instructions in your bandsaw manual.  
Grizzly Industrial, Inc © 1996  
 

Grizzly Cordless Saw G8598 User Manual
Grizzly Indoor Furnishings H7861 User Manual
Haier Clothes Dryer GDZ35 61 User Manual
Hearth and Home Technologies Indoor Fireplace 6000TRS CE User Manual
Heath Zenith Door 598 1000 07 User Manual
Honeywell Water Heater XLS 278 User Manual
HP Hewlett Packard Calculator 48gII User Manual
IBM Laptop 27P2076 User Manual
IFoundry Systems Network Card IFSYS 7000 User Manual
Iiyama Computer Monitor B1906S User Manual