Repeat Playback
To Repeat all tracks on a disc
The use of the Microphone
1. Plug the tail-end of the Handy Microphone into the Mic jack
(No.10 on diagram).
2. When using the Microphone turn the switch to on position.
3. Speak in normal voice about 2 inches from the Microphone.
4. Avoid placing Microphone close to speakers of the unit to
prevent squeaking noise due to feedback from speakers.
5. When not using Microphone always disconnect it from the
unit.
1. Push Repeat button twice. Repeat Indicator (REPEAT ALL) lights up.
2. Push Play/pause button to begin repeat playback. When the end
of the last track is reached, the selection returns to track 1 for repeat
play all tracks. To release Repeat function. Push Repeat button. Repeat
indicator goes off. When the end of the last track is reached, the play
stops automatically.
KIDS-CD20
SING-A-LONG
PORTABLE STEREO
WITH COMPACT DISC
DIGITAL PLAYER
To repeat a track on a disc :
1. Push the forward skip button until the desired track number
appears in the Track Number Display.
2. Push Repeat button. Repeat Indicator (REPEAT 1) lights up.
3. Push Play/pause button to begin repeat playback. When the end of
the track is reached, the playback of the track is repeated.
Specifications
General
Power Source:
Output power:
Speakers:
DC12V “C”Size battery x8, (UM2, IEC R14)
1.5w + 1.5W
(3”) Full range Speaker x 2
Headphones 16-50 ohms
(Recommended 32 ohms)
255mm(L) X 190mm(W) X 120mm(H)
1.2 KG
Installing Batteries:
Load Impedance:
You will need 8 “C”size batteries. (1.5V x 8)
NOTE: Alkaline batteries will normally last longer and reduce the
possibilty of battery leakage.
1.Open Battery Door
2. Install Batteries As Shown
Dimensions:
Weight:
CD Play
Type: Compact Disc player
Audio Channels: 2
Wow And Flutter: Unmeasurable (Less than 0.001% W.Peak).
NOTE: Watch carefully the and ends of the batteries If you don’t
install batteries correctly the set will not work.
CAUTION
NOTE: If the sound becomes weak and unclear, the batteries may be
weak. Replace all eight batteries at once.
NOTE: Remove batteries if unit is not to be used for a long period of
time (about 30 days or more ) to prevent battery leakage and possible
damage to the unit.
IT IS IMPORTANT TO CHECK REGULARLY FOR DAMAGE TO THE
CORD PLUG ENCLOSURE OR OTHER PARTS OF THE ADAPTOR TO
PREVENT FROM POTENTIAL HAZARDS.
THE TRANSFORMER USED WITH THE TOY MUST COMPLY WITH
THE REQUIREMENT OF EN60742
BATTERY INSTRUCTIONS
Do not mix old and new batteries.
Instruction Manual
Do not mix alkaline, standard (carbon-Zinc) or rechargeable (Nickel-
Cadmium) batteries.
PRODUCT SUPPORT
Non- rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the toy before being
charged.
Only batteries of the same or equivalent type as recommended are to
be used.
™
For technical support, contact us:
Email: [email protected]
Phone: 1-800-631-0868
Batteries are to be inserted with the correct polarity.
Exhaused batteries are to be removed for the toy.
The supply terminals are not to be short-circulted.
|