Harbor Freight Tools Air Cleaner 95176 User Manual

AIR BLAST DRAIN CLEANER  
95176  
ASSEMBLY AND OPERATING INSTRUCTIONS  
Due to continuing improvements, actual product may  
differ slightly from the product described herein.  
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Copyright © 2006 by Harbor Freight Tools®. All rights reserved. No portion of this  
manual or any artwork contained herein may be reproduced in any shape or form  
without the express written consent of Harbor Freight Tools.  
For technical questions and replacement parts, please call 1-800-444-3353  
 
9. Do not overreach. Keep proper footing and balance at all times.  
10. Maintain tools with care. Keep tools clean for better and safer performance.  
The Pistol handle must be kept clean and dry at all times.  
11. Stay alert. Watch what you are doing, use common sense. Do not operate  
any tool when you are tired.  
12. Check for damaged parts. Before using any tool, any part that appears  
damaged should be carefully checked to determine that it will operate  
properly and perform its intended function. Check for alignment and binding  
of moving parts; any broken parts or mounting fixtures; and any other  
condition that may affect proper operation. Any part that is damaged should  
be replaced.  
13. Do not operate tool if under the influence of alcohol or drugs. Read  
warning labels if taking prescription medicine to determine if your judgment or  
reflexes are impaired while taking drugs. If there is any doubt, do not operate  
the tool.  
14. Maintenance. Thoroughly wash all components in warm, soapy water after  
each use.  
Warning:The warnings, cautions, and instructions discussed in this instruction  
manual cannot cover all possible conditions and situations that may occur. It  
must be understood by the operator that common sense and caution are factors  
which cannot be built into this product, but must be supplied by the operator.  
Unpacking  
When unpacking, check to make sure the following parts are included. See photo  
below and refer to the Parts List. If any parts are missing or broken, please call  
Harbor Freight Tools at the number on the cover of this manual.  
(1)  
(2)  
(3)  
(5)  
(4)  
SKU 95176  
For technical questions, please call 1-800-444-3353  
 
Page 3  
Operation  
Note: This product is designed for household use; not for industrial applications.  
1. Select one of the Adapters that best fits the drain size.  
2. Snap the Adapter onto the end of the Pistol.  
See photo below. Use the largest Adapter for the toilet bowl, the smaller ones  
for sinks and other drains.  
3. Remove all loose particles from the drain and sink area.  
4. Fill the drain with warm, soapy water if possible.  
The Air Powered Drain Cleaner works best when the drain is filled with warm,  
soapy water, up and over, the rubber Adapter.  
5. When possible, support the bottom of the drain trap to keep the air blast from  
damaging the trap.  
Warning: Do not use the Air Powered Drain Cleaner if the sink or drain is filled  
with any type of caustic drain cleaner or flammable material. This liquid could  
splash back into your hands or face and cause burns or blindness. Do not air  
blast the drain pipe if the pipes are not in good condition. Damage could occur.  
6. Plug or cover the sink’s overflow hole (or air vent) with a wet cloth to keep the  
clogged substance from being flushed back out of the hole.  
When unplugging a toilet, cover the bowl (on both sides of the Pistol) to keep  
debris and liquids from splashing out of the bowl.  
7. Pump the Pistol Piston 5 to 10 times when unplugging a sink. For a toilet,  
pump up to 40 times (maximum).  
8. Securely place the Pistol with Adapter squarely over the drain, then pull the  
Trigger.  
9. Repeat these steps until the drain is cleared, and water flows freely.  
SKU 95176  
For technical questions, please call 1-800-444-3353  
 
Page 4  
Maintenance  
1. Never submerse the entire Pistol in water.This will damage the Pistol air  
reservoir.  
2. After each use, thoroughly clean the Adapter with warm, soapy water.  
3. Wipe the Pistol clean with a cloth rinsed in warm, soapy water. Dry all parts  
after cleaning.  
4. Store all components and a clean and dry location.  
5. Before storing the Pistol, pull the Trigger and release all air pressure.  
Parts List  
Item  
Description  
1
2
3
4
5
Pistol  
Adapter: 7-3/4” (OD) x 1-3/4”  
Adapter: 4-3/8” (OD) x ¾”  
Adapter: 1-3/8” (OD) x 1-5/8”  
Adapter: 1” (OD) x 1-7/8”  
NOTE: Some parts are listed and shown for illustration purposes only and are not  
available individually as replacement parts.  
PLEASE READ THE FOLLOWING CAREFULLY  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM  
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR  
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE  
BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR  
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT,  
THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THat ALL REPAIRS  
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND  
LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK  
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT  
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION  
OF REPLACEMENT PARTS THERETO.  
SKU 95176  
For technical questions, please call 1-800-444-3353  
 
Page 5  

Hamilton Beach Popcorn Poppers Hot Air Popcorn Pumper User Manual
Hamilton Beach Slow Cooker 33041 User Manual
Heatcraft Refrigeration Products Air Compressor 25006801 User Manual
Heatiator Indoor Fireplace GB4336 User Manual
Hotpoint Dishwasher LTB 4B019 User Manual
Hotpoint Oven RMBA 2200L User Manual
HP Hewlett Packard Calculator HP 6S User Manual
Hunter Fan Fan 20345 User Manual
Hyundai DVD Player H CMD7080 User Manual
iLive MP3 Docking Station IB319B IB User Manual