Note: Refer to your user’s guide for information about cleaning your
device.
Connecting the Scanner
RS232 Serial Port:
When connecting the scanner, make sure the cable is pushed tightly
into the scanner. Loosen the locking plate and slide it over the base
of the cable connector to lock the cable in place. Tighten the screw.
Getting Started
Turn off computer’s power before connecting the scanner, then
power up the computer once the scanner is fully connected.
Power Supply Assembly (if included)
Granit™ 1280i
Industrial Full Range Laser Scanner
Quick Start Guide
Reading Techniques
Note: The power supply must be ordered separately, if needed.
查看繁体版请登陆 www.honeywellaidc.com
Standard Product Defaults
The following bar code resets all standard product default settings.
Standard Product Defaults
1280-QS Rev A
1/14
Suffix
Function Code Transmit
Data Format Editor Instructions
Programming Chart
If you want a carriage return after the bar code, scan the Add CR
Suffix bar code. To add a tab after the bar code, scan the Add Tab
Suffix bar code. Otherwise, scan the Remove Suffix bar code to
remove the suffixes.
When this selection is enabled and function codes are contained
within the scanned data, the scanner transmits the function code to
the terminal. Charts of these function codes are provided in your
User’s Guide.
The following are abbreviated instructions for entering a data format.
For complete instructions refer to your User’s Guide, available at our
website, www.honeywellaidc.com.
0
1. Scan the Enter Data Format symbol.
2. Primary/Alternate Format: scan 0 for Primary Format
3. Terminal Type: scan 099 for any terminal type
4. Code I.D.: scan 99 for any bar code type
5. Length: scan 9999 for any length bar code.
6. Editor commands: use the Programming Chart that follows.
7. Scan Save to save your entries.
1
2
3
4
5
6
Add CR Suffix
Enable
(Default)
Add Tab Suffix
Disable
Remove Suffix
Enter Data Format
Add Code ID Prefix to all Symbologies
Scan the following bar code if you wish to add a Code ID prefix to all
symbologies at once.
Clear All Data Formats
Add Code ID Prefix To All Symbologies
(Temporary)
Save
Note: For a complete list of Code IDs, see the User’s Guide for your
7
|